Richard installed a Badger 100 ⅓ Continuous Feed Garbage Disposal, which is manufactured by InSinkErator.
Open the faucet and check for any leaks.Seal all the connections for the new P-trap, depending on what type of piping is chosen.The hole for the drain line is usually on the side of the disposal, so new drain pipes will need to be run and connected. It usually can twist right on and be hand tightened. Attach the disposal to the mounting ring that’s attached to the sink flange.If the dishwasher hose needs to drain into the garbage disposal, most models come with a knockout hole that you can punch through to run the hose.Older models will use three screws that can be tightened with a screwdriver, and many models now use a plastic, hand-tightened ring. From underneath, secure the sink flange to the counter.Apply plumber’s putty to the bottom of the new sink flange and place it in the drain hole.Clean the old putty on the top of the sink. GUARD & STRAINER & STOPPER - Dont have to take it away while the garbage disposal is working, just lift it up, Let water into the drain and prevents silverware, jewelry, and other non-food related items from slipping into the disposal, it also can work as a stopper, hold water in your sink.Now is the time to remove the garbage disposal, to do so, grab a flat screwdriver and insert it into the lower mounting ring. Disconnect the sink stopper and the tail pipe from the sink, which can be done from underneath with a wrench. Now you should remove the dishwasher, before you proceed to disconnect the garbage disposal, you will have to disconnect first the dishwasher drain line by using a pair of pliers.Keep a bucket underneath the P-trap for any waste or sludge that might have built up in the pipes. Tips for Keeping Your Garbage Disposal Running The garbage disposal is one of the mainstays of the kitchen, but it is also one of the most abusedTips for Keeping Your Garbage Disposal RunningThe. Install a T-fitting and PVC pipe to span from the drainpipe to the disposer. Run PVC pipe from the sink trap to the tailpiece that protrudes down from the sinks basket strainer. Lift the disposer onto the lock ring and tighten with a screwdriver. Cut the P-trap near where it exits the cabinet, which is most likely from the side or the back of the cabinet, with a mini hacksaw. Remove the knockout plug from the side of the disposer using a screwdriver.Disconnect the P-trap from the drain tail pipe with a wrench.
HOW TO REMOVE A GARBAGE DISPOSAL AND INSTALL SINK STRAINER HOW TO
These are the steps for how to install a garbage disposal. It’s very easy to get confused in the plumbing aisle, so Richard breaks down the various PVC piping and fittings that can be found. People might want to try to install one themselves, so it’s important to understand the basics involved with the installation, particularly the parts and pieces that are needed. How to Clean a Garbage Disposal Steps for Installing a Garbage Disposal
0 kommentar(er)
